Gas fireplace repair pros serving Northdale

Checking the switch side of the circuit

On a millivolt system, the wall switch, remote receiver or thermostat closes the circuit that tells the valve to open the main burner. The service manual includes a test for this, jumping the switch terminals at the valve for a moment, which shows whether the fault sits in the control or in the valve itself.

Corroded terminals, loose wire nuts and long runs of thin wire can drop enough voltage to leave the burner dark while the pilot keeps burning. Our pros clean, tighten or replace the control wiring as the test shows, and the jumper never stays in place after testing.

Controls that have been under water

Gas fireplace manuals are blunt about flooding, and an appliance with any part that was under water must not be used. A wet valve or control can corrode inside where no one can see it, so the maker's direction is to have a qualified technician inspect the fireplace and replace any control part that got wet.

After a roof leak, a burst pipe or flooding, leave the fireplace off and let our team in Northdale look it over. We list every control that needs replacing, with upfront pricing, before any part is ordered.

Telling the kinds of gas fireplace apart

Gas fireplaces come in a few families that are serviced differently. Direct-vent units are sealed behind glass and vent through a wall or roof cap, natural-vent units draw room air and vent straight up, vent-free units have no vent at all, and log sets and inserts sit inside an existing fireplace.

Our pros identify the type during the free inspection in Northdale before discussing repairs. Vent-free units carry their own service rules, and we treat them as their own job when that is what you own.

What your written estimate lists

Every repair we quote in Northdale comes with a written estimate that separates what we found from what we recommend. You see the model, the symptom, the tests we ran and the part or service each line pays for.

Upfront pricing means the number you approve is the number you pay, and you save 10% by approving it within 72 hours of the free inspection.

• The fault we found and the reading or check behind it
• Each part by name, listed for your model
• Cleaning or adjustment work on its own line
• Any vent, glass or supply issue quoted separately