Chimney rebuild in Sun City Center
Family-owned rebuild specialists who take a failed chimney down to sound masonry and build it back properly in Sun City Center, after a free inspection.
- Family owned and operated
- Same-day service available
- No hidden fees
- Workmanship warranty
Contents
Our Services
Our Approach to Rebuilding Chimneys in Sun City Center
What our chimney rebuild specialists check, choose and build on a chimney in Sun City Center.
Wall thickness in the rebuilt section
New chimney walls go back at a nominal 4 inches or more, built of solid units or of hollow units filled solid with grout, which is the minimum in Florida's residential code.
That figure assumes a flue lining inside. BIA's historical guidance shows that unlined chimneys called for walls twice as thick, which is one reason every rebuilt flue is lined. Thin spots left by earlier patching in the retained section below are pointed out, because the new work rests on them.
Our crew builds the new walls to the code thickness and fills every joint, so the rebuilt section is solid rather than a shell around the flue.
Mortar for new chimney brickwork
BIA recommends Type N portland cement-lime mortar for chimneys, and accepts Type S where wind or other sideways forces on the stack are high.
The general rule in BIA's mortar note points the same way, toward the weakest mortar type that still does the job. Stronger is not automatically better. Mixing is done by measured volume on site so each batch matches the last, which keeps the color and strength even across the new section.
For your rebuild, the pick between N and S depends on height, exposure and brick, and the estimate names it.
Rebuilding a chimney that carries two flues
Chimneys with more than one flue get a masonry partition, called a wythe, between each pair. In a rebuild it goes back at least 4 inches thick and built into the chimney walls, as the state code requires. A cracked or missing partition lets smoke from one flue find its way into the other.
There is an exception for two flues venting a single appliance, which may sit side by side with their joints staggered at least 4 inches.
Our rebuild crew rebuilds each partition to the rule and keeps every flue separate from bottom to top of the new section.
Details that help before the rebuild inspection
Before the visit, tell us what you have seen, such as fallen brick, a lean, a gap at the wall or water inside, and roughly when it started.
Mention earlier repairs, planned roofing work and how the fireplace is used. If an engineer or home inspector has already looked at the chimney, their notes help. A short description of what changed and when is enough to start.
There is nothing to measure or climb. Our crew handles access and measurements on the free visit.
On any service we offer
Partial or full, the rebuild is 10% off for 72 hours after the inspection.
Free Inspection
Checked Before Any Brick Comes Down in Sun City Center
- Masonry partitions between neighboring flues
- Cap sized to the rebuilt flue
- Ties anchoring the chimney to the house
- Permit requirements for the address
Our Services
More Help for Your Sun City Center Fireplace
-
-
-
-
-
-
More about chimney rebuildEverything we do in Sun City Center
Rebuild That Crumbling Chimney Top
Down to sound brick and back up with a new crown and flashing, for chimneys in Sun City Center.
Your request is confirmed
Our team will contact you to arrange the appointment.