
Stucco chimney repair that fixes the cause in Tampa Heights
Honest advice on patch or restucco for your chimney in Tampa Heights, with a written price for each path.
- Family owned and operated
- Same-day service available
- No hidden fees
- Workmanship warranty
Contents
Our Services
How We Repair Stucco Chimneys in Tampa Heights
Our specialists cut back to sound edges, build proper coats and keep every patch damp while it cures.
Tapping the stucco to find loose areas
Sound stucco rings solid when tapped, while stucco that has lost its bond gives a dull, hollow note. Preservation Brief 22 from the National Park Service recommends tapping gently with a wooden or acrylic hammer to map those areas, and it warns that heavy sounding can break the keys holding good stucco in place.
Our specialists tap the chimney face in a grid and mark every hollow spot before quoting. That map sets the size of the repair, so you pay for the stucco that has actually failed and none that is still holding well.
A crown that throws water clear of the stucco
For a masonry chimney, the Florida Building Code, Residential wants the crown pitched so water runs off it, edged with a drip, and sealed at every flue liner by a caulked bond break. A drip edge keeps runoff from sheeting down the chimney face below it.
When a crown is flat, cracked or flush with the chimney face, water runs down the stucco and into every crack. Our specialists check the crown on each stucco job and quote crown repair as its own line when it is part of the problem.
Coatings and a chimney that needs to dry
A chimney gets wet from rain on the outside and sometimes from moisture within, and it has to dry out again. According to the International Masonry Institute, a film-forming coating or a water repellent can reduce absorption yet may also slow drying once water gets in.
Our pros weigh that trade-off on your chimney before recommending a coating, and they fix the leaks first so less water reaches the wall at all. When a vapor-open product fits better, the estimate says so.
Bulging stucco on a chimney
A bulge in stucco is a section that has pulled away from its backing and is being pushed out, often by rusting lath or water behind it. Left alone, a bulge can crack open and fall away in pieces.
Our pros sound the area around a bulge to find its true edges, since the loose zone is often larger than the visible swelling. The section is removed, the backing is repaired and new stucco is built up in coats to match.
On any service we offer
In Tampa Heights, stucco work booked in the 72 hours after the inspection is 10% off.
Free Inspection
The Checks Behind Your Stucco Repair Price
- Flashing where the chimney meets the roof
- Paper layer behind framed stucco
- Finish texture to be matched
- Brick or block joints under the stucco
Our Services
More Help for Your Tampa Heights Fireplace
-
Chimney Leak Repair Trace the water entry before choosing the repair, so the work addresses the cause rather than covering the stain. Learn more
-
Chimney Cap Installation and Replacement Replace a damaged or missing cap with a compatible fit that covers the opening without obstructing the chimney. Learn more
-
Chimney Repair Repair damaged chimney parts and deal with the cause, with a free inspection before you choose the work. Learn more
-
Gas Fireplace Installation Choose a gas fireplace that fits the room and can be installed with the required venting, supply and clearances. Learn more
-
Chimney Chase Repair Repair the enclosure around the chimney while respecting the pipe system and tracing the water damage that affected it. Learn more
More about stucco chimney repairEverything we do in Tampa Heights
Get Your Stucco Chimney Repaired in Tampa Heights
Hairline cracks to full restucco, every repair comes with an upfront price and our workmanship warranty.
Your request is confirmed
Our team will contact you to arrange the appointment.