Gas fireplace repair and tune-ups in Tampa Heights

Relighting after a propane tank runs dry

When a propane tank runs out, the pilot goes out with it. The model fuel gas code has the piping leak-checked right after gas service comes back from an interruption, and the fireplace is relit only once that check is done.

Propane is heavier than air and settles low, which is why lighting instructions ask you to smell near the floor before relighting. If you smell gas, leave the house and call your gas supplier or 911 once you are outside. Otherwise, our pros can relight and test the fireplace after a delivery.

A glass front that seals the firebox

On a direct-vent fireplace, the glass panel and its gasket close the combustion chamber off from the room. Makers warn that the fireplace should not run with the glass removed, cracked or broken, and the glass assembly has to be latched in place before use.

Our pros check the latches, the gasket and the glass edges on every service. When the glass or its gasket needs replacing, we quote that as its own job with the part listed for your model.

Testing a full cycle before we leave

A repair is finished when the fireplace lights, runs and shuts down the way its manual describes. Our pros light the pilot or trigger the ignition, run the burner long enough to see the flame settle, test the remote or switch and watch the shutoff.

On natural-vent units we also check that exhaust is leaving through the vent, and on every unit we recheck any fitting we touched. You see the fireplace working before we pack up in Tampa Heights.

What your written estimate lists

Every repair we quote in Tampa Heights comes with a written estimate that separates what we found from what we recommend. You see the model, the symptom, the tests we ran and the part or service each line pays for.

Upfront pricing means the number you approve is the number you pay, and you save 10% by approving it within 72 hours of the free inspection.

• The fault we found and the reading or check behind it
• Each part by name, listed for your model
• Cleaning or adjustment work on its own line
• Any vent, glass or supply issue quoted separately